Iracing Force Feedback Test Program3/27/2021
You can also enable it and set it to a lower number like 25 or 50.Since this was originally written, Logitech has released newer wheels, the Logitech G29 and the Logitech G920 wheels which are very similar to the G27.If you need help setting up a Logitech G27 or G29 racing wheel, have a look at this page.
Iracing Force Feedback Test Program Software That IsCalibration and settings for all three of these wheels is similar, but the new ones come with new software that is reported to work better with later versions of the Windows Operating System. I have experimented quite a bit with my wheel settings and I believe I have found the settings that suit me the best on both asphalt and dirt ovals. At first I tried to follow any official iRacing instruction or documentation that I could find. In general that works pretty well and some people swear by those settings. After I had been an iRacing member for a couple of years I started experimenting with my wheel settings and found that the iRacing recommendations werent really the best for me in some cases. Im going to give you my own version of iRacings recommended wheel settings for Logitech wheels so lets get to it, step by step. If youre using Windows 10, click Start, then type Control Panel. If youre using the new software provided with the G29 and G920 wheels, it will look quite different. According to iRacing it should be set to 0. I would make new images but I dont use the Logitech G27 racing wheel any more so I dont have access to the software.). ![]() Go with it and try it for a while or read on if you want to try my settings. You can adjust min force as you begin using the wheel in the simulation. If the wheel oscillates, chatters or vibrates while you are driving straight, you need to turn down the min force. If you arent feeling small force feedback inputs, you should turn up the min force. Min force is not needed on the Logitech G29 and G920 racing wheels. When you return to center, make sure Pos: should be close to or right at 50. I use the hex screw heads around the center of the G27 wheel to set mine. Most wheels fall somewhere around 870 instead of exactly 900. In my opinion, for most asphalt racing this is a good way to go; however, for short ovals and dirt I recommend different settings which I detail below. Keep in mind that I run dirt ovals almost exclusively, but these setting work fine for me on short asphalt ovals also. If you have any comments, questions, or discussions, join Discord. For better detail on this, look at my Logitech G29 and G920 page.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |